Edging with Interlocking Rings
Edging with Interlocking Rings by Dagmar Pezzuto ©2014
Here is another charming tatting pattern shared by Dagmar Pezzuto. It is tatted with regular rings, split rings and interlocking rings. Two shuttles are required to achieve this effect. Since there are interlocking rings, celtic style, the shuttle will need to pass through a completed ring. This means that at least one shuttle must be the narrow celtic style. Or, this may be tatted using a blunt needle as if it were a shuttle, or in regular needle tatting style.
Abbreviations
CTM = continuous thread method
R = ring
CH = chain
- = picot
SR = split ring
JK = josephine knot/ring
clr = close ring
rw = reverse work
dnrw = do not reverse work
bts = bare thread space
The order of work is straightforward. Regular ring, chain, josephine ring, chain, cloverleaf, chain, josephine ring, interlocking ring and lastly, a split ring.
Pattern:
R1 4 - 20 clr rw
CH1 8 dnrw
Using shuttle 2 tat JK 12 clr dnrw, continue chain 8
DNRW before nor after the cloverleaf
Cloverleaf
R2 3 - 3 - 3 - 3 clr dnrw leave no bts
R3 3 + (join to last p of R2)1, (- 1)x10, 3 clr dnrw leave no bts
R4 3 + (join to last p of R3) 3 - 3 - 3 clr dnrw
CH2 8 dnrw
Using shuttle 2 tat JK 12 clr dnrw, continue chain 8
Pass the thread through R1 and begin R5
R5 20 - 4 clr dnrw
SR6 3 - 1 - 1 - 3 / 9 clr dnrw
Repeat for desired length.
Celtic style shuttles are available in many materials and colors today. Here is one set of two bamboo narrow celtic style shuttles handcrafted by Georgia Seitz. This size will pass through all the openings shown in this piece of tatting.
You Should Also Read:
Interlocking Rings
Related Articles
Editor's Picks Articles
Top Ten Articles
Previous Features
Site Map
Content copyright © 2023 by Georgia Seitz. All rights reserved.
This content was written by Georgia Seitz. If you wish to use this content in any manner, you need written permission. Contact Georgia Seitz for details.